STUBBINGS BROS LTD

JANSEN JX-72RS WOOD CHIPPER TRACTOR MOUNTED

Out of Stock

Contact us for a price


JANSEN JX-72RS WOOD CHIPPER TRACTOR MOUNTED


The Jansen JX-72RS is new in our shredder range. With its hydraulic retraction, working with this machine is a real pleasure. There is no pushing, pushing, etc. with this model; the 2 feed rollers do this alone. The speed of the feed rollers can be varied continuously using a control valve. This is important in order to match the feed speed to the diameter of the shredded material. Smaller diameters can be drawn in faster than larger diameters.

Should the feed still block, the feed can be put into reverse mode via the large bracket on the funnel. Furthermore, the feed can also be switched off using this bracket. The supply takes place via the tractor hydraulics; What is needed is a pressure flow and a pressure-free return or a double-acting control unit. A liter output of approx. 10 l / min is required to operate the feed rollers. sufficient.

The wood chipper is delivered complete with PTO. A shear pin is installed on one side of the PTO shaft, which for safety reasons serves as a predetermined breaking point in the event of blockages or overloads. Larger tractors with more than 100 HP can be used without any problems.

You should have at least 55 horsepower. The PTO speed must be 540 rpm. be.

The hopper has an opening of 91x70 cm at the top; in the lower area the opening measures 21x29 cm. A maximum of fresh wood up to a diameter of approx. 16 cm can be shredded. Many competitors give the maximum shredded material diameter equal to the dimensions of the lower filling opening, but this information is unrealistic and can trigger the safety mechanism in the PTO.

The rear part of the hopper can be easily folded up for transport and secured with split pins.

The machine is very easy to maintain; so you can open the entire flywheel cover by loosening just one screw and have access to the 4 cutting blades. These cutting knives have blades on both sides so that they can be easily rotated if necessary. The flywheel has a dead weight of 96 kg and has attached wings, which generate the very strong pull through which the shredded material is ultimately blown out through the discharge funnel. Clogging of the shredder is almost impossible due to this very strong draft.

The discharge funnel has a height of approx. 217 cm (plus the lower link lift) and can be rotated 360 degrees. The ejection angle can also be changed very easily. The Jansen JX-72RS hurls the shredded material up to 10 meters!

The shredder is designed for 3-point suspension and can be used from Cat. I.

Technical specifications:

  • Tractor output: min. 55 hp
  • Hydr. Flow rate: from 10 l / min.
  • Recording: 3-point from cat. I
  • PTO: included
  • RPM: 540
  • Number of knives: 4 knives, 1 shear bar
  • Rotor diameter: 72 cm
  • Rotor weight: 96 kg
  • Length of feed chute: 100 cm
  • Max. Wood diameter: 16 cm
  • Filling chute height: 70 cm (lower edge)
  • Ejection height: 210 cm
  • Feeding: (via tractor hydraulics) by 2 hydraulic feed rollers
  • Dimensions built up: 290x125x220 cm (LxWxH)
  • Transport dimensions: 215x125x210 cm (LxWxH)
  • Weight: approx. 695 kg
  • Dimensions packaging: 217x132x156 cm (LxWxH)
  • Weight m. Packaging: 760 kg




SKU:.NJX-72RS
...